I. SURFACE PREPARATION
All surfaces must be considered dirty and must be cleaned prior to the application of markings. Recommended cleaning procedures for glass and plastic substrates are listed below.

Saturate a clean cloth with a 2 to 1 mixture of water and isopropyl alcohol and wipe the surface. (Cleaners such as Windex Window Cleaner may be used.) Wipe the surface dry with a clean, dry, lint-free cloth.

II. TEMPERATURE REQUIREMENTS
Air and application surface temperatures must be 50-85 degrees F.

III. APPLICATION INSTRUCTIONS - FLAT SURFACE ONLY

A. Use 1"-2" (2.5 - 5 cm) strips of masking tape to position marking in proper registry.	B. Apply horizontal tape hinge at the top of the marking	C. Remove liner entirely. Keep exposed adhesive off substrate. Spray water and detergent solution (1/2 part liquid dish water detergent to 991/2 parts water) on substrate.
D. Allow marking to drape. Using firm initial squeegee pressure, begin at top center and work down and outward to each edge of mask.	E. Allow adhesive to bond (generally 15 to 30 minutes.)	F. Remove premask at 180 (pull back on itself).
G. Re-squeegee entire marking.